I’m back with more on the concrete house number I wrote about last week.
So, Mini approved, so I continued.
Then I gathered my materials. Concrete (the fine kind), a bucket to mix in and some milk cartons.
I’m not getting into detail on how I made the numbers for the mold but basically I cut out the numbers from the foam core board and then cut pieces that went in between them to create 3D letters. For the straight sections I did longer pieces and for the curved passages I just made tiny little pieces. No need to be super precise in cutting these, just as long as they are all the same depth and don’t protrude outside the numbers. I used a glue gun for the assembly.
Here’s where the milk cartons come in. Milk cartons are great for concrete projects as they’re water resistant and slightly glossy so they’re easy to remove from the concrete once it’s set.
I was super lucky here to realize that the depth of my letters turned out to be exactly the depth of our milk cartons so I cut the cartons open and got four strips out of each one which was great. I used hot glue to stick the strips to my number carcasses. I used the existing folds on the carton to get sharp edges where I could and when I needed to I used duct tape for reinforcement.
The scissors are by Fiskars by the way and in case you’re wondering. The pattern’s not really my thing but I was happy to send some old wonky craft scissors packing and let a set of these move in with me in my hobby room via a surprise package earlier this summer. Can’t get away from the fact that there are NO better scissors out there.
So after a bit of hot gluing and taping i was left with a 3D milk carton clad 2 and a 7.
Are you getting the picture?
Stay tuned for the rest and the reveal!